Grabber®
1/4 x 2-3/4-in -in Eye Lag Drive, Eye Lag Fine Thread, Streaker® Point Screws (Bulk)
Item Number: H-3
The self-tapping and sharp-point screws are installed without the need for pre-drilling holes in the receiving material. Fasteners are installed with an eye-lag jig pole, 1/4-inch (6.4 mm) hex driver and a variable-speed drill having a minimum speed of 200 rpm.
Specifications
Application:Into Metal
Bit Tip:Eye Lag Driver
Coating:Clear Zinc
Gauge:1/4
Head Type:Eye Lag
- Grabber eye-lag screws are more evenly heat treated and tempered resulting consistent and reliable performance.
- Grabber eye-lag screws begin with the best available materials and conform to strict manufacturing requirements in thread forming. This means the screws will drive faster and will hold better.
- Grabber’s extra sharp 23˚ Streaker® point design starts immediately into light gauge steel and is much less likely to flop over.
- Attaches hanger wire to wooden ceiling joist
- ©2012 GRABBER Construction Products, Inc. GRABBER®, STREAKER®, DRIVALL®, LOX®, GRABBERGARD® and SCAVENGER® are registered trademarks of Grabber Construction Products, Inc.
- The self-tapping and sharp-point screws are installed without the need for pre-drilling holes in the receiving material. Fasteners are installed with an eye-lag jig pole, 1/4-inch (6.4 mm) hex driver and a variable-speed drill having a minimum speed of 200 rpm.
Specifications
Application:Into MetalBit Tip:Eye Lag DriverCoating:Clear ZincGauge:1/4Head Type:Eye LagLength:2-3/4-inPackage Type:BoxPoint Type:23° Streaker® PointThread Type:Fine Thread