Attaches heavy gauge 20-8 ga. metal to metal. Hex head framing screw used in heavy gauge metal to metal applications where high torque is required.
Hydrogen Embrittlement:
Grabber’s 10, 12 & 14 gauge zinc-plated drill point fasteners are manufactured in ISO 9002 factories, plated as prescribed in the ASTM F1941-10 Standard Specification for Electrodeposited Coatings on Threaded Fasteners, and post-plating baked according to the process articulated in SAE AMS 2759/9, Hydrogen Embrittlement Relief (Baking) of Steel Parts, Section 3.3.3.1, and SAE J78, which calls for a four-hour minimum time for baking out entrapped hydrogen after acid treating the parts.
Specifications
Application : Metal to Metal
Bit Tip : Nut Driver
Coating : Clear Zinc
Gauge : 10
Head Type : Hex Head
Length : 2
Metric Size : 50.8
Package Type : Bulk
Point Type : Tek 3 Drill Point
Thread Type : Fine Thread
- Hex washer head design provide maximum torque and holding power in metal to metal framing applications.
- The hex washer head design provides a larger load bearing surface for better holding power.
- Grabber drill point hex washer head screws begin with the best available materials and conform to strict manufacturing requirements in thread forming. Extra sharp threads mean screws will drive faster and will hold better.
- Consistently formed extra sharp drill point starts and drills easily into heavy gauge metal framing.
- Use a standard screwgun with a depth-sensitive nose piece. Suggested screwgun specification for optimal performance – 4 amps minimum and RPM range of 0 to 2,500.
- The hex head is fully seated when the head is flush with the work surface.
- Overdriving my result in fastener failure or strip out of the work surface.
- The fastener must penetrate beyond the metal three full thread pitches.
- For heavy gauge steel-to-steel attachment 43 mil (18ga) or thicker.
- All GRABBER® screw products are manufactured in facilities that are ISO 9001 certified. The fasteners comply with ASTM C1513 requirements. Specific fasteners are listed in ICC ESR-1271; please check the report for listed item numbers. ©2012 GRABBER Construction Products, Inc. GRABBER®, STREAKER®, DRIVALL®, LOX®, GRABBERGARD® and SCAVENGER® are registered trademarks of Grabber Construction Products, Inc.
Attaches heavy gauge 20-8 ga. metal to metal. Hex head framing screw used in heavy gauge metal to metal applications where high torque is required.
Hydrogen Embrittlement:
Grabber’s 10, 12 & 14 gauge zinc-plated drill point fasteners are manufactured in ISO 9002 factories, plated as prescribed in the ASTM F1941-10 Standard Specification for Electrodeposited Coatings on Threaded Fasteners, and post-plating baked according to the process articulated in SAE AMS 2759/9, Hydrogen Embrittlement Relief (Baking) of Steel Parts, Section 3.3.3.1, and SAE J78, which calls for a four-hour minimum time for baking out entrapped hydrogen after acid treating the parts.Specifications
Application: Metal to MetalBit Tip: Nut DriverCoating: Clear ZincGauge: 10Head Type: Hex HeadLength: 2Metric Size: 50.8Package Type: BulkPoint Type: Tek 3 Drill PointThread Type: Fine Thread