Scorpion®
10 x 1-1/2-in Phillips, Bugle Head, Coarse Thread, Sharp Point, Phosphate Screws (5-LB)
Item Number: LAMFP
Scorpion Type G drywall laminating screws for temporary fastening of gypsum to gypsum.
Specifications
| Application | Drywall to Drywall |
|---|---|
| Bit Tip | Phillips |
| Head Type | Bugle Head |
| Thread Type | Coarse |
| Coating | Phosphate |
| Point Type | Sharp Point |
| Gauge | 10 |
| Metric Gauge | 4.8 |
| Length | 1 1/2 in. |
| Head Diameter | 0.354 in. |
| Package Type | 5-LB |
| Amount | 675 |
| Threads Per Inch | 8 |
Also available in
- Bulk LAM
- Pail LAMPAIL
- 5-LB LAMFP
- 1-LB LAMPP
- Pack LAMCP
Available in other lengths
- 1 1/2 in. LAMFP
- 3 1/2 in. HT312FP
- 4 in. HT400FP
Benefits
- The Phillips recess is a precision recess designed for better bit engagement resulting in less wobble or strip-out.
- The Bugle Head screws are more evenly heat treated and tempered resulting consistent and reliable performance.
- Scorpion® Bugle Head screws begin with the best available materials and conform to strict manufacturing requirements in thread forming. Extra sharp threads mean screws will drive faster and will hold better.
- The Sharp Point design starts immediately and is much less likely to flop over.
Recommended Application
For laminating drywall
Installation Guidelines
- Use a standard screw gun with a depth-sensitive nose piece. Suggested screw gun specification for optimal performance - Size #6 - #10 up to 4,000 RPM.
- The Bugle Head is fully seated when the top of the head is below the surface of the wallboard in accordance with Section 7.2.2 of ASTM C1002.
- The fastener must penetrate beyond the metal a minimum of three full threads.
- Overdriving my result in fastener failure or strip out of the work surface.
Special Features
Perfect for fastening the end board to EG Steel studs
Trademark
©2012 GRABBER Construction Products, Inc. Scorpion® is a registered trademark of Grabber Construction Products, Inc.