Grabber®
14-20 x 1-1/2-in Hex Head, Fine Thread, Tek 5 Slotted Drill Point GrabberGard® Gray Screws (Bulk)
Item Number: 1420150H5RG
Attaches heavy gauge 43 mil (18ga) or thicker metal to metal. Hex head framing screw used in heavy gauge metal to metal applications where high torque is required.
ICC-ES Evaluated
ESR-1271 Report
Specifications
| Application | Metal to Metal |
|---|---|
| Bit Tip | Nut Driver |
| Head Type | Hex Head |
| Thread Type | Fine |
| Coating | GrabberGard® Gray |
| Point Type | Tek 5 Drill Point |
| Gauge | 14-20 |
| Metric Gauge | 6.1 |
| Length | 1 1/2 in. |
| Head Diameter | 0.335 in. |
| Package Type | Bulk |
| Amount | 2000 |
Benefits
- Hex washer head design provides maximum torque and holding power in metal to metal framing applications.
- The hex washer head design provides a larger load bearing surface for better holding power.
- GrabberGard® limited lifetime exterior-grade coating provides additional protection against corrosion in most exterior applications.
- Consistently formed extra sharp drill point starts and drills easily into heavy gauge metal framing.
Recommended Application
For heavy gauge steel-to-steel attachment 43 mil (18ga) or thicker.
Installation Guidelines
Use a standard screwgun with a depth-sensitive nose piece. Suggested screwgun specification for optimal performance RPM range of 0 to 2,500. Because of significantly higher torque output, care and caution should be exercised when using an impact driver, otherwise screw failure or spin out may occur.
- The hex head is fully seated when the head is flush with the work surface.
- Overdriving my result in fastener failure or strip out of the work surface.
- The fastener must penetrate beyond the metal three full thread pitches.
Trademark
All GRABBER® screw products are manufactured in facilities that are ISO 9001 certified. ©2012 GRABBER Construction Products, Inc. GRABBER®, STREAKER®, LOX®, GRABBERGARD® and SCAVENGER® are registered trademarks of Grabber Construction Products, Inc.