8 x 9/16-in Phillips, Modified Truss Head, Fine Thread, Streaker® Point Phosphate Screws (1-LB)
Item Number: X31
Used for light gauge metal applications where low profile head exposure is desired. Streaker point means quick and easy penetration into metal (25-20 ga.), while wafer head provides greater bearing surface. The right screw for K-lath installation.

Used for light gauge metal applications where low profile head exposure is desired. Streaker point means quick and easy penetration into metal (25-20 ga.), while wafer head provides greater bearing surface. The right screw for K-lath installation.
Specifications
Application:Metal to Metal
Bit Tip:Phillips Bit Tip
Coating:Phosphate
Gauge:8
Head Type:Modified Truss Head
- Grabber’s Pro-Fit™ # 2 Phillips recess is a precision recess designed for better bit engagement resulting in less wobble or strip-out.
- The modified truss head design provides a larger load bearing surface for better holding power. Under head serrations lock tight in metal to metal applications.
- Grabber fine thread modified truss head screws begin with the best available materials and conform to strict manufacturing requirements in thread forming.
- Grabber's extra sharp Streaker® point design starts immediately and is much less likely to flop over.
- Use a standard screwgun with a depth sensitive nose piece. Suggested screwgun specification for optimal performance – Size #6 - #10, up to 4,000 RPM.
- The Modified Truss Head is fully seated when the bearing surface of the head is flush with the work surface.
- The fastener must penetrate beyond the metal three full thread pitches.
- Overdriving may result in failure of the fastener or stripout within the substrate.
Light gauge 18-30 mil (25-20ga) steel framing. K-lath installation.
All GRABBER® screw products are manufactured in facilities that are ISO 9001 certified. The fasteners comply with ASTM C1513 and ASTM C1002 specifications and requirements. ©2012 GRABBER Construction Products, Inc. GRABBER®, STREAKER®, LOX®, GRABBERGARD® and SCAVENGER® are registered trademarks of Grabber Construction Products, Inc.
Used for light gauge metal applications where low profile head exposure is desired. Streaker point means quick and easy penetration into metal (25-20 ga.), while wafer head provides greater bearing surface. The right screw for K-lath installation.
Specifications
Application:Metal to Metal
Bit Tip:Phillips Bit Tip
Coating:Phosphate
Gauge:8
Head Type:Modified Truss Head
Length:9/16-in
Package Type:1-lb
Point Type:Streaker® Point
Thread Type:Fine Thread
Amount:259