8 x 3-7/8-in Phillips, Modified Truss Head, Fine Thread, Streaker® Point, NanoGard™ Screws (Bulk)
Item Number: SPLH378RG
Scorpion Type S/P Modified Truss Head fine-thread screws are designed for attaching wire lathing, framing, and other materials to metal 18-30 mil (25-20 gauge) studs.
Scorpion Type S/P Modified Truss Head fine-thread screws are designed for attaching wire lathing, framing, and other materials to metal 18-30 mil (25-20 gauge) studs.
Specifications
Application:Metal to Metal
Bit Tip:Phillips Bit Tip
Coating:NanoGard™
Gauge:8
Head Type:Modified Truss Head
- The #2 Phillips recess is a precision recess designed for better bit engagement resulting in less wobble or strip-out.
- The modified truss head design provides a larger load bearing surface for better holding power.
- NanoGard™ exterior-grade coating provides additional protection against corrosion in most exterior applications.
- The extra sharp Streaker® point design starts immediately and is much less likely to flop over.
-
- Use a standard screw gun with a depth-sensitive nose piece. Suggested screw gun specification for optimal performance - Size #8 up to 4,000 RPM.
- The Modified Truss Head is fully seated when the bearing surface of the head is flush with the work surface.
- The fastener must penetrate beyond the metal a minimum of three full threads.
- Overdriving my result in fastener failure or strip out of the work surface.
- Light gauge 18-30 mil (25-20ga) steel framing. K-lath installation.
- ©2012 GRABBER Construction Products, Inc. Scorpion®, & Streaker® are registered trademarks of Grabber Construction Products, Inc.
- Scorpion Type S/P Modified Truss Head fine-thread screws are designed for attaching wire lathing, framing, and other materials to metal 18-30 mil (25-20 gauge) studs.
Specifications
Application:Metal to MetalBit Tip:Phillips Bit TipCoating:NanoGard™Gauge:8Head Type:Modified Truss HeadLength:3-7/8-inPackage Type:BulkPoint Type:Streaker®Thread Type:Fine ThreadTPI:15Amount:1000