10 x 1-5/8-in Phillips, Wafer Head, Fine Thread, #3 Winged Drill Point, NanoGard™ Screws (Bulk)
Item Number: T3PW10158
Scorpion Type T3PW Wafer Head winged drill point screws are designed for attaching plywood and sheathing to heavy gauge metal. Performance range is 1/4" to 3/4" lumber to 43-118 mil (18-10 gauge) steel.
Scorpion Type T3PW Wafer Head winged drill point screws are designed for attaching plywood and sheathing to heavy gauge metal. Performance range is 1/4" to 3/4" lumber to 43-118 mil (18-10 gauge) steel.
Specifications
Application:Cement Board to Metal
Bit Tip:Phillips Bit Tip
Thread Type:Fine Thread
Head Type:Wafer Head
- Scorpion hex head self-drilling screws comply with ASTM C1513 for cold-formed steel framing connections. Salt spray tested according to ASTM B117 for 1000 hours; 15 cycles Kesternich per DIN 50018; no red rust. Approved for use in non-coastal areas with all pressure treated lumbers including ACQ.
-
- Use a standard screw gun with a depth-sensitive nose piece and use extra caution when installing with an impact driver. Suggested screw gun specification for optimal performance - Size #8 - #10 up to 2,500 RPM.
- The Wafer Head is fully seated when the top of the head is flush with the work surface.
- The fastener must penetrate beyond the metal a minimum of three full threads.
- Overdriving my result in fastener failure or strip out of the work surface.
- For attaching cement board to heavy gauge metal 43 mil (18ga) or thicker.
- Wings
- ©2012 GRABBER Construction Products, Inc. Scorpion® is a registered trademark of Grabber Construction Products, Inc.
- Scorpion Type T3PW Wafer Head winged drill point screws are designed for attaching plywood and sheathing to heavy gauge metal. Performance range is 1/4" to 3/4" lumber to 43-118 mil (18-10 gauge) steel.
Specifications
Application:Cement Board to MetalBit Tip:Phillips Bit TipThread Type:Fine ThreadHead Type:Wafer HeadPoint Type:Winged Drill PointGauge:10Coating:NanoGard™Length:1-5/8-inPackage Type:BulkTPI:24Amount:3000